“C51”簡單造句，C51造句子

介紹了一種基於C51單片機和光纖技術的液位測量儀的系統設計。

系統的軟件設計由C51語言編程來實現，系統由十一個模塊構成，各個模塊完成特定的功能。

單片機端通信程序採用C51編程，使用UART接收結束中斷、UART發送結束中斷。

“基於C51的數據採集電路pcb的設計與製作”是針對現代水利行業水情數據採集而設計製作的電路pcb。

REALIZATION OF CHINESE-CHARACTER DISPLAY ON FLOWMETER INTERFACE WITH C51 PROGRAMM

It introduces the design of a liquid level measurement system based on the C51 single chip microcontroller and optical fiber technique.

給出了X5045芯片與AT89C52單片機的硬件接口電路，用C51語言編寫了其軟件接口程序。

在此前提下以C51硬件開發語言為基礎，給出了8051單片機與T6963C的接口電路框圖，並以字符、圖形的具體顯示方法為例簡要介紹了軟件的設計流程及實現。

It is written in a C51 liquid crystal display of the temperature measuring device, can display the measured temperature.

This dissertation is mainly about designation of the hardware circuit and system programming with C51 according to the designing objective in length.

軟件設計中採用彙編語言、C51語言編寫數據採集程序和對usb接口芯片進行協議處理及數據交換的程序。

The modular programming approach is adopted on the software design and code is writed in C51 language.

Presents the internal configuration of LCD module MSC-G12864 and its operation method. On these, discuss the interface with MCU and gives out programming method and some C51 program.

Software development adopts C51, which improved the development efficiency and reduced the development cost.

本文詳述了使用VB和C51實現PC機和單片機串行通信的開發方法，並簡要地介紹了VB通訊控件及其使用方法，給出了調試程序。

這是用C51編寫的有液晶顯示的温度測量儀，能顯示測量的温度。

In this paper, the software of the system was designed based on modular design concept, and programming language C51 was adopted.

用C51對DS1302進行程序設計，能加強DS1302的通用*和可移植*，有一定的實用價值。

C51 prepared through the buttons adjust brightness led procedures, have an adjustable timer with PWM.

現場*器由數據採集卡和網絡通訊卡組成，現場控制卡負責接收*中心發出的控制命令，它們都是由一塊51單片機控制，其軟件開發都是使用了C51和51彙編程序。