7、As we can see in that figure, the depth of cut (and consequently the load) gradually increases on the successively engaged cutting edges.
1、This particular model predicts the depth of cut achievable with any given set of process parameters.
5、In this paper, effects of depth of cut and feedrate on mechanical properties of metallic fiber are investigated by spinning bit.
10、In many cases of stainless steel cutting operations with carbide tools, a tool life strongly depends on flank notch wear of depth of cut rather than average flank wear of main cutting edge.
6、Grasping the top, knurled section of the depth adjustment rod (Q), slide it up so that the TAB (EE) aligns with the desired depth of cut on the pillar scale (FF).
3、Dry and wet masonry blades provide a consistent depth of cut with less dust than abrasives.
2、(2)Only depth of cut and federate have effects on material removal rate (MRR).
4、A quadratic model of predicting helical milling force was researched. The effects of spindle speed, feed per tooth, and axial and radial depth of cut were analyzed.
9、The axial feed is provided by the carriage or the compound rest, either manually or automatically, whereas the depth of cut is controlled by the cross slide.
8、During a facing operation, feed is provided by the cross slide, whereas the depth of cut is controlled by the carriage or compound rest.
國文精選館
