This echoes from its new high-fidelity machined chassis, representing the most exacting manufacturing process of any laptop made today.
For influence factors and rules of machined surface roughness, we studied on the influence factors of machined surface roughness such as scallop-height, path interval, feed rate and optimum tool path.
These dies are shorter in productive cycle and lower in cost than machined dies. A good developing prospect about these dies has been shown.
The first piece machined by each worker in every group (the operating group) needs to inspect by themselves, or by the other , and by the specialist (three types of inspection).
Socked and plug are precision machined from solid bar stock.
Lager dies are usually roughed out, then stress-relieved and finish-machined.
Lead in solders for the soldering to machined through hole discoidal and planar array ceramic multilayer capacitors.
Through experiments of high speed lapping with solid abrasives, the effect of lapping pressure on machined surface roughness is studied in this paper.
refined machined reflecting round chisel
To calculate the electrostatic force in the micro machined gyroscope is a key problem in the mechanical characteristic of it.
And planing want more than slot machines, slot machines can not be processed sheet planing, planing wave plate groove machined easily broken.
Deep eyelet belongs to hard to be processed machine parts. It is widely used in engineering and practice. But it is very difficult to be machined by traditional cutting method.
It means that in rough lapping the value of machined surface roughness can be reduced with lapping pressure increasing.
With the continuous application of ultra-hard high speed steel and other materials hard to be machined in tool industry, higher requirements have been put foward to the grinding process for tools.
Errors Analysis of Silicon Micro-machined Gyroscope Driven by Rotating Carrier
Ensure that the lathe dog is secured to the machined flat on the end of the mandrel and not on the smooth surface of the mandrel taper (Figure 7-44).
The interior dimensions of brazing valve sockets are machined to the closest tolerances and finished smooth to promote full capillary attraction.
The rotor is then heated and press fit onto a cooled precision-machined one-piece stainless steel shaft and the assembly is then machined and balanced as a unit.
On the basis of this, process planning of 8 ducts of 4 specifications are designed and machined. The products fully meet the requirements of the drawing.
The production of ramie gauze and fabric is machined only then at 80 time initial stage.
The edge of the disc had been machined flat/smooth.
國文精選館
